1W FM TRANSMITTER DRIVER EXCITER
PROFESSIONAL RANGE

Our new range of PLL Stereo Transmitters integrate the Aareff Crystal Coder, PLL Drive and Power Amp to give you everything you need, all in one enclosure. This neat combination is suitable for driving our power amplifiers.

Any frequency between 87.5 to 108MHz can be accurately programmed on the internal dip switches and tuned up in about 10 mins.

Expensive test equipment is NOT required, set up is a simple task using the LED's on the front panel. The transmitter operates from a 13.8V DC supply, this makes it suitable for use on a standard power pack or automobile power system anywhere around the world.

This FM transmitter along with all our other products comes with a full twelve month guarantee and our reputation of high reliability. On delivery the equipment is ready to plug in and use with any suitable 50 ohm antenna system such as our Vertical 5/8 Wave, Single Dipole or Stacked Dipole.

• 13.8VDC or 115/230 VAC 50/60 Hz with optional PSU
• RF Output 1W +/- 0.5 dB from -20 to +40 Deg C
• RF Output Connector BNC
• RF Harmonics >75dB rtc
• RF Spurious >63dB rtc
• Out of Lock Suppression >63dB rtc
• Freq 100KHz steps from 87.5 to 108MHz
• Stability Extreme +/- 2 KHz from -20 to +40 Deg C
• Stability Normal +/- 300 Hz at 20 Deg C
• Fine Freq. Adj.> +/- 1000Hz
• Freq Adj. Accuracy+/- 50 Hz
• Deviation Sensitivity Stability +/-2% max
• Audio In Phono/RCA type unbalanced sockets
• Pre-emph (50uS/ 75uS/ None) Selectable
• Audio Level 0.775 V rms for +/- 75 KHz
• Signal to Noise Ratio 80 dBu
• Audio Freq MPX. +/- 0.5dB 30 Hz to 76 KHz
• Audio Freq Stereo +/- 0.5dB 30Hz to 15 KHz
• Audio Distortion Better than 0.02 % THD
• Stereo Crosstalk better than 35dB
• Stereo Pilot Tone 19KHz
• Pilot Tone Stability 0.2Hz
Geolocation by geoPlugin